dirna Bergstrom bycool REVOLUTION Instrucciones De Montaje página 26

REVOLUTION
EN
6
Place waterproof joints
a- (2) for short hatch
b- (4) for long hatch
6
7
Assemble previously mentioned set on Bycool
base and secure using indicated screws, to
which a piece of provided sealer will be added
(detail x). In remaining holes, place waterproof
plugs (detail y) after putting them in water to
facilitate their placing.
a- Seal all around edge, from inside, as shown,
by applying a thread of silicone.
8
IMPORTANT: Point screws and always
tighten them from sides to centre so that
waterproof joints adjust perfectly.
As in point 7 but for a long hatch. In this case,
put waterproof plugs on both sides of the (4)
holes remaining exposed, thus preventing
water from entering.
6a
(detail y)
7
7a
(detail x)
8
26
6b
®