dirna Bergstrom bycool DINAMIC 1.1 Instrucciones De Montaje página 21

DINAMIC 1.1
On the studs, thread (3) M6 nuts with (3) flat
8
washers Ø 6, which should be level with the
cover.
SEE ATTACHED DIAGRAM
VERY IMPORTANT
!
In the case of slanting upholstery, the evaporator
unit must be vertical or sloping from the lower
section to the outside in order to prevent the
condensation water from dropping onto the
upholstery.
Pass drain tube through the hole of the base
9
of the evaporator drain pan.
Pass the cabling through the Ø 35 bore towards
10
the exterior.
Upholstery
Evaporator
bracket
Wastewater
tray
10
Lorry sheet
OUTSIDE
M6 self-blocking
nut
Protector cap
M6 Stud
Wide ring flat
washer
Rubber washer
9
21
Upholstery
INSIDE
M6 Nut
Evaporator
(leave at
base
M6 Nut upholstery height)
M6 Nut
Wide ring
Wide ring
flat washer
flat washer
EN
®
8
10