Adjusting The Depth Stop - Greencut TDC600C Manual De Instrucciones

58
DEPTH STOP AND DEPTH SCALE
The depth stop and depth scale allow you to drill holes at a defined depth. Either method can be used.

ADJUSTING THE DEPTH STOP

1. Install the necessary drill bit.
2. Mark the desired drilling depth (H) on one side of the workpiece.
3. Lower the drill until it reaches the mark and hold the shaft crank in this position.
4. Turn the lower nut (B2) downward to contact the depth stop tab (13).
5. Turn the upper nut (B1) downwards and tighten it against the lower nut. The downward movement of the
spindle will stop when the nuts reach the depth stop stop.
USING THE DEPTH SCALE
1. Install the necessary drill bit
2. Mark the desired drilling depth (H) on one side of
the workpiece.
3. Lower the drill until it reaches the mark and hold the
shaft handle in this position.
4. Note where the indicator (G) points to the depth
scale (E). Optionally, tighten the depth stop nuts (B1
/ B2).
5. When drilling, stop when the pointer reaches the
desired position on the depth scale.
ADJUSTING THE TABLE ANGLE
1. Loosen the table lock nut (h) with a suitable wrench.
2. Turn the table (3) to the desired angle and hold it in this position. There's a ladder and a pointer at the top
of the table.
3. Tighten the lock nut firmly.
3
h
G
B1
B2
13
H
E