Ignition 123ROVER-8-R-V Instrucciones De Montaje página 6

If curve '5' is an improvement, you may try curve '6', but listen carefully for evidence of knock under
heavy load. If curve 6 is an improvement, select curve 7 and again listen carefully for evidence of knock
UK
under heavy load. If knock is detected, step back to the last curve. Engines run under sustained knock
conditions can be severely damaged!
If you have any doubt about tuning, please seek advice from a knowledgeable engine tuner.
Technical data
operating voltage
RPM range
temperature
coil
engines
firing order
static LED-timing
Curve
(switch setting)
0
1
2
3
8,0 to 15,0 Volts, negative earth only
8000 engine revolutions per minute
-30 to 85 degrees Celsius
"High Energy"-coil , primary resistance not below 0,6 ohms
most Rover-V8 engines ; advance-curves selectable by a switch through the
bottom of the housing
1-8-4-3-6-5-7-2 ( in a clockwise direction )
TDC ( applies to all 16 curves )
degr.advance
@ 400-1000 rpm*
5,0
5,0
5,0
5,0
degr.advance
@ rpm*
12,0@2400
14,0@2400
16,0@2400
18,0@2400
Max.degrees
advance@rpm*
20,0@4400
20,0@4400
20,0@4400
20,0@4400