Troubleshooting; Troubleshooting Chart; Fcc And Ic Compliance Statement - Allmand Night-Lite E-Serie Manual Del Operador

Troubleshooting

Before performing any troubleshooting
procedures, read Safety.

Troubleshooting Chart

Problem Possible Cause
Lights not No power. Make sure
working power cord is connected
between unit and 120-
volt supply.
Main breaker off. Turn on
main breaker.
No light (one Light switch(es) off. Turn
or more on light switch(es).
lights)
Photocell / Light Operation Mode
Timer and not set correctly. See
Manual Light Operation Mode.
control not
working
Photocell Too little ambient light.
stays on or Make sure that noth-
does not ing is blocking pho-
function tocell. See Photocell
properly Operation. Or switch to
Timer or Manual control.
Low voltage. Power
cord gauge too small or
length too long.
Photocell Too much ambient light.
stays off or Move away from light,
does not or switch to Timer or
function Manual control.
properly
Unit not Unit malfunction. Contact
working authorized dealer.
FCC and IC Compliance
Statement
FCC Part 15 Information To User
Pursuant to part 15.21 of the FCC
Rules, you are cautioned that changes
or modifications to the product not
expressly approved by Briggs &
Stratton could void your authority to
operate the product.
This device complies with part 15 of the
FCC Rules.
Operation is subject to the following
two conditions: (1) This device may not
cause harmful interference, and (2) this
device must accept any interference
received, including interference that
may cause undesired operation.
This equipment has been tested and
found to comply with the limits for a
Class B digital device, pursuant to part
15 of the FCC Rules. These limits are
designed to provide reasonable pro-
tection against harmful interference in
a residential installation. This equip-
ment generates, uses and can radi-
ate radio frequency energy and, if not
installed and used in accordance with
the instructions, may cause harmful
interference to radio communications.
However, there is no guarantee that
interference will not occur in a particu-
lar installation. If this equipment does
cause harmful interference to radio
or television reception, which can be
determined by turning the equipment
off and on, the user is encouraged to
try to correct the interference by one or
more of the following measures:
• Reorient or relocate the receiving
antenna.
• Increase the separation between the
equipment and receiver.
• Connect the equipment into an out-
let on a circuit different from that to
which the receiver is connected.
19
en