Changing The Battery - Dornbracht 35 730 970 90 Instrucciones De Montaje

Fig. 7
Fig. 8
11
6 7 8 9 10
Fig. 9
Exposed trim parts
Cut off the hood 4 of the wall installation box flush
with the tiles.
Take care not to damage the lead and high
pressure connecting hose.
Fit mounting frame 5 with the enclosed fastening
materials on hood 4 of the wall housing.
Screw the high pressure connecting hose 6 to the
spout.
Plug the lead 8 into the socket 10. Push the
composite shaft 9 into the sleeve 7. Engage
covering rosette 13 in the top of mounting frame 12,
press it on flush at the base and secure with
threaded pin 14.
Take care not to damage the lead and high
pressure connecting hose.

5.0 CHANGING THE BATTERY

If the LED in the upper sensor lens 1 is flashing, the
battery needs changing.
Remove the old battery 15 from the holder and
replace with a new one.
When operated in conjunction with hydraulic flow
5
heaters, flow reducer 11 must be removed.
6.0 TROUBLESHOOTING
There is no flow of water
• The water supply has been interrupted.
» Check the water supply
• The upper LED is flashing – the battery is spent.
» Change the battery
• The solenoid valve is faulty.
» Change the solenoid valve
• The sensor lenses are dirty.
» Clean the sensor lenses
• The volume control on the spout is dirty.
» Change the volume control
The fitting does not switch off
• The diaphragm of the solenoid valve is dirty
or faulty.
» Clean or change the diaphragm.
• The solenoid valve is faulty.
» Change the solenoid valve
The flow rate has changed
• The water supply is restricted.
» Open valves
Fig. 7
• The aerator is blocked.
» Clean or change the aerator.
• The back-flow preventer is dirty.
» Clean the back-flow preventer
Fig. 8 The temperature cannot be altered
• The mixer valve is faulty.
» Change the mixer valve
Fig. 9
Fig. 10
Fig. 11
Fig. 8
12
X
13
14
Fig. 10
Fig. 11 GB