Handling The Remote Controller - Toshiba RAS-M10GDCV-E Manual Del Propietário

HANDLING THE REMOTE CONTROLLER

CAUTION
• The air conditioner will not operate if curtains, doors or other materials are blocking the signals sent from the remote controller
to the indoor unit.
• Prevent any liquid from falling into the remote controller.
Do not spill juice, water or any kinds of liquids.
• If the infrared signal receiver on the switch panel is exposed to direct sunlight, the air conditioner may not function properly.
Use curtains to prevent reaching the receiver from direct sunlight.
• If the air conditioner is installed in a room which has fluorescent lights with electronic starters or inverter system, signals may
not be properly received and the air conditioner can't start or stop while the lights go on. If you are planning to use such
fluorescent lights in the same room where the air conditioner operates, consult your local dealer.
• If other electrical appliances react to the remote controller of the air conditioner, either remove these appliances or consult your
local dealer.
Location of the remote controller
• Keep the remote controller where its signals can reach the receiver
on the switch panel (maximum distance is 7 m).
• When you select the timer operation, the remote controller
automatically transmits a signal to the indoor unit at the specified
time.
If you keep the remote controller in a position that hinders proper
signal transmission, a time lag of up to 15 minutes may occur.
Remote controller holder
Installing the remote controller holder
• Before you install the remote controller holder on a wall or pillar,
check whether the remote controller signals can be received by the
indoor unit.
Mounting and removing the remote controller
• To mount the remote controller, hold it parallel to the remote
controller holder and push it in fully. To remove the remote controller,
slide the remote controller upwards and take it out from the holder.
Receiving section on switch panel
When the receiving section receives
the signal, a receiving sound is
issued from the indoor unit.
pip, pip : Operation
Long pip : Stop
pip : Change
9
Receiving
section on
switch panel
Approx. 7 m
Transmitting section
of remote controller
EN