Troubles And Causes (Concerning Remote Controller) - Toshiba RAS-M10GDCV-E Manual Del Propietário

TROUBLES AND CAUSES (Concerning Remote Controller)

Before you ask for servicing or repairs, check the following points:
Symptoms
The fan speed can not be
changed.
Symptoms
The remote controller signal is
not transmitted even when the
ECO. or FAN button is pushed.
Symptoms
The TEMP. indicator does not
go on.
(for cooling only model)
Symptoms
The indication on the display
disappears after a lapse of
time.
The TIMER indicators go off
after a lapse of certain time.
Symptoms
No receiving tone sounds from
the indoor unit even when the
START/STOP button is
pushed.
EN
Setting Change is Impossible.
Causes
• Check whether the MODE indicated
on the display is "AUTO".
AUTO
• Check whether the MODE indicated
on the display is "DRY".
(DRY)
The Transmission Indicator " " Never Goes On
Causes
• Check whether the ON TIMER is
indicated on the display.
The Display Never Goes On
Causes
• Check whether the MODE indicated
on the display is "FAN ONLY".
(FAN ONLY)
The Display Goes Off
Causes
• Check whether the timer operation
has come to an end when the OFF
TIMER is indicated on the display.
• Check whether the timer operation is
started when the ON TIMER is
indicated on the display.
The Signal Receiving Tone Does Not Sound
Causes
• Check whether the signal transmitter
of the remote controller is properly
directed to the receiver of the indoor
unit when the START/STOP button is
pushed.
22
Description
When the automatic mode is selected,
the air conditioner automatically
selects the fan speed.
When dry operation is selected, the air
conditioner automatically selects the
fan speed.
Description
The remote controller signal is not
transmitted, because the air
conditioner is off.
Description
The temperature can not be set during
fan only operation.
Description
The air conditioner operation stops
since the set time elapsed.
When the time set to start the air
conditioner is reached, the air
conditioner will automatically start and
the appropriate indicator will go off.
Description
Direct the signal transmitter of the
remote controller to the receiver of the
indoor unit, and then repeatedly push
the START/STOP button twice.