Using The Dc Kit - Waeco DC-Kit2 Instrucciones De Montaje Y De Uso

DC-Kit2.book Seite 29 Freitag, 13. Juni 2008 3:09 15
DC-Kit2
7.6 Connecting the DC kit to the power supply
➤ Check that all the connections have been made in accordance with the
instructions.
➤ Check that the roof air conditioner is closed properly.
➤ Connect the electrical connections of the components (
➤ Connect the 230 V connection on the roof air conditioner to the socket on
the ECW-012VS inverter (
➤ Connect the positive battery cables to the batteries.
➤ Check the following are working properly:
– Check the on and off values for the charging voltage regulator
– Check the priority circuit
– Switch on the air conditioning in driving mode (
– Switch on the air conditioning on mains operation
8

Using the DC kit

The DC-Kit2 consists of several components, each with its own installation
and operating manual. Use the installation and operating manuals for the
components and make sure you are familiar with the individual devices.
This chapter contains information on operating the overall system. This op-
erating manual does not replace any information contained in the installation
and operating instructions for the components.
e
Caution!
CA2500, B2200: the inverter may be damaged.
Ensure that these models are not used in the air conditioning or
heating modes for driving. The inverter is not designed for generat-
ing this amount of power.
e
Caution!
CA2500, B2200: the inverter may be damaged.
If you are operating the system on the 230 V mains and the auto-
matic air conditioner or the heating is on, make sure that the invert-
er is switched off and stays switched off.
The inverter is not designed for the amount of power an active heat-
ing system requires. If the 230 V mains power fails, the inverter
would then take over supplying the power.
ECW-012VS).
Using the DC kit
ECL-102).
air conditioning)
29