Installing Components - Waeco DC-Kit2 Instrucciones De Montaje Y De Uso

DC-Kit2.book Seite 27 Freitag, 13. Juni 2008 3:09 15
DC-Kit2
7.2

Installing components

I
Note
DC Kit 2 contains two different remote controls for the inverter:
– CA2500, B2200: remote control FB1 (is included in the scope
of supply of the inverter)
– B1600: remote control FB2
➤ Install the ECL-102 charging current distributor.
➤ Install the ECW-012VS inverter.
➤ B1600: Fit remote control FB2 in an easily accessible location in the ve-
hicle.
e
Danger of electrocution
Only connect the battery once you have the completed all the in-
stallation work and you are certain it has been done properly.
7.3 Connecting the CA2500 Dometic roof air condi-
tioner
➤ Remove the air outlet of the roof air conditioner (
page 3).
➤ Cut the cable loop of the CA2500 on/off cable through the middle
(fig. 2 A, page 3).
➤ Connect the control cable to the on/off cable (fig. 2 B, page 3).
➤ Lay the control cable of the roof air conditioner to the ECL-102 charging
current distributor.
➤ Cut off round system plug (fig. 2 C, page 3).
➤ Connect both ends of the cable with connections I2 and I3 of the charging
current distributor (
➤ Attach the air outlet of the roof air conditioner (
page 3).
➤ Run the connection cable of remote control FB1 to the inverter and con-
nect ( ECW-012VS).
Installing and connecting the DC kit
ECL-102) (fig. 3 1 and 2, page 4).
CA2500) (fig. 1,
CA2500) (fig. 1,
27