Daga PM-150V Instrucciones De Uso página 22

also confirm the user by leaving the screen for 3 seconds with the
desired user.
3) If the monitor has stored results, the LCD screen will momentar-
ily display the most recent one. Zero will appear on the LCD screen
if no results have been stored.
4) The monitor will talk with reading tips if the voice function is
active.
5) The monitor then starts to search for zero pressure.
6) The monitor then inflates the cuff until enough pressure has
been accumulated for a reading. The monitor then slowly releases
the air pipe and performs the reading. Finally, blood pressure and
pulse rate will be calculated and displayed on the LCD screen.
7) The blood pressure rating and irregular heartbeat symbol will
flash on the display.
8) The result is automatically stored on the monitor
9) When the reading is taken, the monitor will switch off automat-
ically after 1 minute of non-operation. Alternatively, you can press
the "START" button to turn off the monitor manually.
10) You can press the "START" button to turn off the monitor man-
ually during the reading.
Please note: Consult a health care professional for the interpretation
of the pressure readings.
Viewing the results stored
Following the reading, you can review the reading in the current
memory bank by pressing the "MEM" button.
Alternatively, press the "MEM" button to display the results stored.
The current memory bank will flash and will display the number of
results in this bank.
Press the "START" button to switch to another bank.
Confirm the selection by clicking the "MEM" button. The current
bank can also be confirmed automatically after 5 seconds of not
being operational.
After you select the memory bank, the LCD display will show the
average values in this bank.
If no results is stored, the LCD display will show zeros.
Press the "MEM" button to switch to the following scene.
22