babymoov A047009 Instrucciones De Uso página 10

Setting the timer
- Press the button twice, the programme will enter the timer programming mode. The clock screen will flash and
display "12.00".
- Press the "+" or "-" button to set the desired countdown for the start of vaporisation.
- Each setting unit is 30 minutes and the setting is only valid for minutes. For example, when the screen indicates
12:30, press the "+" button once, the screen will change to 13:00 (note: when you press the "+" or "-" button and
maintain the pressure, the minutes increase or decrease automatically). Please note that each stage is 30 minutes.
- When the setting is complete, press once on the button
Note:
if you have not pressed the button
not complete or recognised in this case.
When you have set the timer, be careful to ensure that you have set the desired humidity level (cf.above "Setting the
desired humidity level (hygrometry) ".
- Setting the time is shown in the form of a countdown. When the countdown is complete, the icon
the LCD screen and humidification will begin.
- You can check the countdown setting by pressing the button
before the digital humidifier begins to work. Flashing of the countdown display will last for 3 seconds and will then return
to the previous display mode. For example, you set the timer to 5:00 (you therefore wish vaporisation to start in 5 hours).
When you go to the timer setting mode after 25 minutes, the display will indicate 04:35.
- To cancel the timer setting: maintain pressure on the button
- If the digital humidifier is turned off, the timer will not work and will return to the original setting.
Nightlight Function
The nightlight function operates independently of the humidification function.
Press the button once: the "blue" luminescent LEDs will light up. Press the button a second time and the "red"
luminescent LEDs will light up. Press the button a third time and the nightlight function will be deactivated.
Locking the dial
- Press the two "+" and "-" buttons at the same time for 5 seconds, the icon
screen. The control panel is then locked.
- Press the two "+" and "-" buttons for 5 seconds, the control panel will be unlocked and the ico
the LCD screen.
Filling the tank with water
When the water level in the tank reaches a minimum level, the icon
This indicates that you should fill the water tank with an appropriate amount of water (max.: 0.5 gallon (2.5 L)).
• Use the following cleaning procedures to ensure that your
digital humidifier works properly and effectively. Good
maintenance is essential to ensure the long-term use of
your digital humidifier and to prevent bacteria forming in
the water inside the tank.
• Risk of electric shock: before cleaning, always unplug the
digital humidifier and ensure that it has cooled down
completely. The digital humidifier can be cleaned easily
with a soft, slightly dampened cloth or sponge. Leave it to
air dry. Never immerse the base in water or any other liquid.
• Regularly clean the water tank (using a bottle brush for
example). Use a mixture of bleach and water to clean
the water tank. Rinse with clean water and allow to dry
naturally. Never use detergent to clean a humidifier part
that is designed to hold water. A cloud of detergent
dissolved in water could interfere with the vaporisation
of your digital humidifier.
10
to confirm the setting. The icon
to confirm, the time setting will continue to flash for 40 seconds. The setting is
MAINTENANCE
DIGITAL HUMIDIFIER • Instruction Manual
once. The display will indicate the time that remains
for 5 seconds.
and the indicator will light up and flash.
• Regularly remove the base. Pour 8.3 fl oz. (250 ml) of
white vinegar into the base. Leave the white vinegar to
act for 20 minutes. Clean all internal surfaces with a soft
brush. Using a soft brush, gently scour all the parts
around the transducer. Be careful not to apply direct
pressure to the transducer. Then empty the vinegar into
the sink. Rinse with clean, hot water.
• Never use a caustic substance, solvent or abrasive
substance for cleaning: they could damage the digital
humidifier and its walls.
• Before putting the digital humidifier away, empty the
tank of water and remove the water remaining in the
main casing. Ensure that all the parts are completely
dry. Leave the cap unscrewed to prevent the joint from
sticking to the tank.
illuminates on the LCD screen.
will go out on
will be displayed on the LCD
will disappear from