Setting The Temperature; Switching Off The Cooler; Performance And Energy Saving Tips; Cleaning And Maintenance - Mobicool MCF32 Instrucciones De Uso

MCF 32, MCF 40 Compressor Cooler
8.7

Setting the Temperature

1. Press the "SET" button once.
2. Use the "+" and "–" buttons to select the cooling temperature.
The cooling temperature appears in the display for a few seconds. The display
flashes several times and then the current temperature is displayed again.
8.8

Switching Off the Cooler

1. Empty the cooler.
2. Switch the cooler off.
3. Disconnect the power.
8.9

Performance and Energy Saving Tips

• Choose a well-ventilated location protected from direct sunlight.
• Only put pre-cooled items in the cooler.
• Do not leave the lid open for longer than required, as this may signifi-
cantly increase the internal temperature.
• Ensure that the cooler is not too full and that air can circulate ade-
quately between the items.
• Defrost the cooler once a layer of ice forms.
• Avoid unnecessarily low temperatures.
9

Cleaning and Maintenance

9.1

Cleaning the Cooler

A
NOTICE!
Never clean the cooler under running water or in dish water. Do not use
abrasive cleaning agents or hard objects during cleaning. Failure to
obey this notice could result in damage to the cooler.
1. Occasionally clean the cooler interior and exterior with a damp cloth.
2. Make sure that the air inlet and outlet vents on the cooler are free of any
dust and dirt, so that heat can be released and the cooler is not dam-
aged.
EN
Cleaning and Maintenance
13