Troubleshooting - Tribest Slowstar Serie Manual De Uso

The Slowstar does not work.
Motor stops during use.
Amount of juice is too little.
Juice Container is shaking in the middle of
operation.
Seems like the Duoblade Auger is grinding.
Hearing a lot of sounds coming from
the Slowstar.
Juice is spilling out of the Slowstar.
After extraction, the color of the Juicing
parts and Juice Container are different.
The Feeding Chute Assembly does not
disassemble easily.

TROUBLESHOOTING

• Check if the power cord is plugged in properly.
• Check if all parts are assembled correctly.
• Check if the power cord is plugged in properly.
• Check if all parts are assembled correctly.
• The Motor may stop if too many juicing ingredients are inserted
at the same time. If this occurs, turn the Switch to "OFF" and then
turn the switch to "Reverse" to unclog the materials. Then turn
the switch to "ON" to push the materials down. (Repeat this step
3 times.)
• Turn the switch to "OFF" and place the Main Body in a cool area.
Let the Slowstar rest for an hour to cool the
motor down and try turning the Slowstar on again.
• Remove all the hard seeds in the juicing ingredients before juic-
ing. Hard seeds may break down the Juicing Screen and Duoblade
Auger.
• Each food produces a different amount of juice depending on
how fresh it is.
• To extract more juice, refrigerate ingredients, then soak for about
10 minutes in clean water before juicing.
• Check if the Pressure Plug is assembled properly.
• It is completely normal if the juice container shakes a little bit
during operation.
• Operating the Slowstar without feeding any food may cause the
Duoblade™ Auger to grind.
• Turn the switch to "OFF" and check if parts are
assembled properly.
• Check if the Slowstar is operating on an uneven surface.
• There may be some squeaky friction noise while in use. This is a
normal sound that occurs, and user should not
worry about it.
• Check if juicing materials are cut to the right sizes.
• Check if pressure plug is assembled properly.
• Right after use, if the Slowstar is not cleaned, then it is more
difficult to clean and may even cause reduced performance.
• Disassemble Silicone Blades and wash them separately.
• Grab the Feeding Chute firmly and rotate it counter-clockwise
with force.
EN
17