DD108
14-12-2007
16:43
solid surface such as a garage floor; never on
anything flammable.
Note: Always switch to a fresh battery when tool
performance begins to diminish. Severe heat is
destructive to batteries; the more heat generated,
the faster the battery will lose power. A battery that
gets tool hot can be permanently damaged.
Never overdischarge a battery by using the tool
after performance decreases. Never attempt to
discharge a battery by continuing to pull the trigger.
When tool performance begins to diminish, stop
the tool, recharge the battery, and use a fully
charged battery for optimal performance.
2. When the Battery Pack-after initial chargere-
quires recharging, it must charge for three to five
hours in order to operate at full power.
3. Charging room temperature: 10°C-40°C (50°F-
104°F)
4. Depress both buttons at the rear of the Battery
Pack and slide the unit down to detach from the
Drill/Driver.
5. The Battery Pack can only fit into the Charger
Base (2) in one position, insert into Charger
Base, plug Charger Base into Charger (Adapter)
( 3 ), and plug Charger (Adapter) into any stan-
dard electrical outlet.
6. While charging, the Battery Pack, Charger
Base, and Charger (Adapter) may become warm
to the touch. This is normal, and does not indica-
te a problem.
7. When the Battery Pack is in the Charger Base,
both the red and green lights on the Charger Base
will be illuminated while charging, when the Battery
Pack is fully charged the red right will turn off, indica-
ting that the Battery Pack is ready for use. Once the
Battery Pack is fully charged, unplug the Charger
from the electrical outlet and remove the Battery
Pack from the Charger (Adapter).
Pagina 9
12. BATTERY CARE
When batteries are not in tool or charger, keep
them away from metal objects.
DO NOT PUT BATTERIES INTO FIRE OR
EXPOSE TO HIGH HEAT. They may explode.
13. RECHARGEABLE BATTERY
Faulty or exhausted lithium ion batte-
ries must be preserved so that they can
be recycled or disposed of accordingly,
in compliance with the provisions of
Directive 91/157/EEC.
Always use separate waste collection containers.
If these are not available, contact the local envi-
ronmental protection body or a Rupes distributor
to ensure that exhaust batteries are disposed of
in accordance with law provisions.
14. GUARANTEE
All tools manufactured by RUPES Spa are gua-
ranteed for 12 months from the date of purchase
against fabrication and material defects.
All tools must be used only with RUPES original
accessories and spare parts: we refuse all
responsibility for damages or accidents caused
by non-observance of this rule which will also
cause the termination of the guarantee.
The guarantee will no longer be valid if the
instructions contained in this booklet are not fol-
lowed, if the tool is used for purposes other than
that for which it is intended, if it is dismantled,
interfered with in any way or damaged due to
neglect.
The guarantee will be made valid by filling-in
the form on the inside back cover of this
instruction booklet.
If the tool is found to be defective or malfun-
ctions, it should be returned carriage free in one
piece in its original packing together with the gua-
rantee certificate to the manufacturer or to one of
the Assistance Centres listed in the appendix to
this booklet.
The guarantee does not automatically imply
replacement of the tool. RUPES Spa reserves
the right to make any technical or design modifi-
cation to its products without prior notice.
The manufacturer is not liable for any print errors.
This document voids and replaces previous
ones.
9