Tabla de contenido
Publicidad
The following information relates to protecting YOUR SAFETY and PREVENTING EQUIPMENT PROBLEMS. To help you recognize this
information, we use the following symbols. Please read the manual and pay attention to these sections.
DANGER
– A POTENTIAL HAZARD THAT WILL CAUSE SERIOUS INJURY OR LOSS OF LIFE.
WARNING
– A POTENTIAL HAZARD THAT COULD CAUSE SERIOUS INJURY OR LOSS OF LIFE.
– A POTENTIAL HAZARD THAT MAY CAUSE MODERATE INJURY OR DAMAGE TO EQUIPMENT.
CAUTION
WARNING
1.
RISK OF FIRE OR EXPLOSION. Never spray flammable
liquids in a confined area with compressor present Compressor
motor and pressure switch produce electrical sparks while
operating. If sparks come into contact with vapors from
gasoline or other solvents, they may ignite, causing fire or
explosion. Always operate the compressor in a well–
ventilated area. Do not smoke while spraying. Do not spray
where sparks or flames are present.
2.
RISK OF BURSTING. Always drain the air compressor tank
daily or after each use. If the tank develops a leak, replace
the air compressor. Never use the air compressor after a
tank leak has been found or try to make any modifications to
the tank. Do not weld, drill or modify the air tank. Welding or
modifications of the air compressor tank can severely impair
tank strength and cause an extremely hazardous condition,
and will void the warranty.
3.
RISK OF ELECTRICAL SHOCK. Never operate the air
compressor in the rain or wet conditions. Any electrical
issues or repairs should be performed by authorized
personnel such as an electrician and should comply with all
national and local electrical codes. The air compressor
should also have the proper three prong grounding plug,
correct voltage, and adequate fuse protection.
4.
RISK OF INJURY. This unit starts automatically. ALWAYS
shut off the compressor, remove the plug from the outlet, and
bleed all pressure from the system before servicing the
compressor, and when the compressor is not in use. Do not
use the unit with the shrouds or belt guard removed. Serious
injury could occur from contact with moving parts.
5.
RISK OF AIR TOOL BURSTING. Check the manufacturer's
maximum pressure rating for air tools and accessories.
Compressor outlet pressure must be regulated so as to
never exceed the maximum pressure rating of the tool.
Relieve all pressure through the hose before attaching or
removing accessories.
6.
RISK OF BURNS. High temperatures are generated by the
pump and manifold. To prevent burns or other injuries, DO
NOT touch the pump, manifold or transfer tube while the
pump is running. Allow them to cool before handling or
servicing. Keep children away from the compressor at all times.
CAUTION
1.
Drain the moisture from the tank on a daily basis. A clean,
dry tank will help prevent corrosion.
2.
Pull the pressure relief valve ring daily to ensure that the
valve is functioning properly, and to clear the valve of any
possible obstructions.
3.
To provide proper ventilation for cooling, the compressor
must be kept a minimum of 12 inches (31 cm) from the
nearest wall, in a well–ventilated area.
4.
Fasten the compressor down securely if transporting is
necessary. Pressure must be released from the tank before
transporting.
E104684
SAFETY GUIDELINES
7.
RISK TO BREATHING. Always read material safety information
before spraying paints or toxic materials, and follow all safety
instructions. Always use a properly qualified respirator mask if
there is a chance of inhaling anything you may be spraying. Read
all instructions to verify that your respirator mask is qualified to
properly protect you for this application. Never directly inhale the
compressed air produced by a compressor. It is not suitable for
breathing purposes.
8.
RISK OF EYE INJURY. Always wear ANSI Z87.1 approved safety
glasses with side shields when the air compressor is in use. Turn
off the air compressor and drain the air tank before performing
any type of maintenance or disassembly of the hoses or fittings.
Never point any nozzle or sprayer toward any part of the body or
at other people or animals.
9.
RISK OF BURSTING. Never modify the air compressor's factory
settings which control the tank pressure or adjust the relief valve
for any reason. Doing so may create an extremely hazardous
condition, and will void all warranties. The relief valve has been
pre-set at the factory for the maximum pressure of this unit.
Personal injury and /or property damage may result if the relief
valve is tampered with.
10. RISK OF BURSTING. Do not use plastic or pvc pipe for routing
compressed air. Use only galvanized steel pipe and fittings for
compressed air distribution lines.
11. RISK TO HEARING. Always wear hearing protection when using
an air compressor. Failure to do so may result in hearing loss.
RISK OF FALLING.Operation of the air compressor should
12.
always be in a position that is stable. Never use the air compressor
on a rooftop or elevated position that could allow the unit to fall or
be tipped over. Use additional air hose for elevated jobs.
13. The power cord on this product contains lead, a chemical known
to the State of California to cause cancer, and birth defects or
other reproductive harm. Wash hands after handling.
NOTE:
serial label for the unit's voltage and amperage requirements. Ensure
that all wiring is done by a licensed electrician, in accordance with the
National Electrical code.
5.
6.
7.
ELECTRICAL WIRING. Refer to the air compressor's
Protect the air hose and electric cord from damage and
puncture. Inspect them weekly for weak or worn spots, and
replace if necessary.
To reduce the risk of electric shock, do not expose to rain.
Store indoors.
Never operate the compressor if the power cord or
plug are damaged. Take the equipment to the nearest
Authorized Service Center, and a specialist technician
will replace it.
3
Publicidad
Tabla de contenido
