How To Use The Remote Control; Loading Batteries; Effective Range Of Remote Control Unit - JVC DLA-HD1 Manual De Instrucciones

Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

How to Use the Remote Control

Loading Batteries

If the remote control has to be brought closer to the projector to operate, it means that the batteries are wearing out. When this
happens, replace the batteries. Insert the batteries according to the +- marks.
Be sure to insert the - end first.
If an error occurs when using the remote control, remove the batteries and wait for 5 minutes. Load the batteries again and
operate the remote control.
The following instruction applies only to the use in Holland.

Effective Range of Remote Control Unit

When directing the remote control
toward this unit
When aiming the remote control towards the
remote sensor on this unit, ensure that the
distance to the sensor in front or at the rear of
this unit is within 7 m.
If the remote control fails to work properly,
move closer to this unit.
When reflecting off a screen
Ensure that total of distance A between this
unit and screen and distance B between
remote control and screen is within 7 m.
As the efficiency of signals reflected from the
remote control unit differ with the type of
screen used, operable distance may
decrease.
This unit
Screen
Remote Control
ENGLISH
Remote Control
This unit
17

Publicidad

Tabla de contenido

Solución de problemas

loading

Tabla de contenido