Maglite Mag Charger RE1019 Manual Del Propietário página 12

Operation - Getting the most out of Your Mag Charger® Rechargeable Flashlight System
Section 5
How To Go From One Function Set To
Your Mag Charger® flashlight's "standard" setting is Function Set #1. If you want
to keep that setting you don't have to do anything. Function Set #1 will always be
in effect unless it is changed. If you want to choose a different function set,
follow these steps:
1. Unscrew the tail cap,
backing it out of the barrel
far enough that the
flashlight will not turn on.
(Note: This may require
the tailcap to be removed
from the barrel entirely).
2. Pause for 2 seconds.
3. Press the switch button
and keep holding it down.
4. While still holding down the switch button, screw the tail cap back in until it is tight.
5. Keep holding down the switch button. Within about 4 seconds the flashlight will
start to blink.
6. The number of blinks indicates the new selected Function Set.
7. To choose a new Function Set, release the switch button after the
corresponding number of blinks (releasing after 1 blink chooses Function Set #1;
releasing after 2 blinks chooses Function Set #2; release after 3 blinks for Function
Set #3, and release after 4 blinks to choose Function Set #4.) Your choice of a
Function Set remains in effect until you change it by repeating the above
process. (See our Demo video at www.maglite.com)
nother
NOTICE: To avoid deeply discharging the rechargeable NiMH battery,
always turn the flashlight off when the flashlight beam starts to dim or
turn yellow.
to be fully recharged. In this case, allow the battery to charge for a full 16
hours.
Spot-to-Flood Beam
Quick focusing "continuous cam-action" spot-to-flood beam. Operates with
a simple quarter turn of the flashlight head assembly.
dim or yellow beam is an indication that the battery needs
11