Maglite Mag Charger RE1019 Manual Del Propietário página 8

The Charging Cradle
Section 2
The Charging Cradle's Quick
Release Mounting Bracket
Turning the Charging Cradle upside down, you will see a release pin on the
same side as the power cord (Fig. 5). Depressing this pin with the index
finger or (closed) ballpoint pen will release the mounting bracket for
installation. When locating and mounting the bracket, be sure that the
release pin (Fig. 6) faces in the same direction as you want the head of the
flashlight to be. Note: Because of the innumerable places that can be
chosen for mounting, there are no screws or fasteners supplied. Be sure to
use fasteners that give maximum holding power for repeated use.
Two mounting brackets are included for location versatility.
Fig. 5
Charging Cradle Clamp
Note the difference, in the following illustrations, between the "clamps
open" position (Fig. 7) and the "clamps closed" position (Fig. 8).
Sometimes one or both clamps (they work independently) will be
inadvertently pushed to the closed position, making it very difficult to
return the flashlight to the recharger/cradle. If this happens, simply take
thumb and forefinger and snap it back to the open position (Fig. 9).
Fig. 6
rms
Fig. 7 Fig. 8
Clamps Clamps
Open Closed
Fig. 9
7