Honeywell SYNC WIRELESS IMPACT Instrucciones De Uso página 5

(C) OPERATING THE HEADSET - Getting started
Turn headset ON/OFF
Adjust hear-through Volume
Adjust Master Volume
PAIR WITH BLUETOOTH DEVICE
The headset will enter Manual Pairing Mode when turned on for the first time (not paired).
1 Turn headset ON by pressing *C1 for two seconds. (See Bluetooth LED table below).
2 Enable Bluetooth on your device and search for new
3 Select [Sync WL xxx] and type pairing code [0000] if required.
Next time the headset is turned ON, it will try to automatically pair with the last paired device. Ensure
Bluetooth is enabled on your device.
To manually pair with a new device:
• Turn headset ON with a long press (press *C1 more than 5 seconds).
• Pair with your device within 60 seconds (See step 2 and 3 above).
Bluetooth will enter sleep mode within 60 seconds if not successfully paired (Time-Out). To reactivate
Bluetooth Automatic Pairing, press button *C1 twice, or restart the headset. You can enter Manual
Pairing Mode from Automatic Pairing mode by pressing *C1 twice again. Powering On with a long press
(5 seconds) will erase the list of paired devices.
BLUETOOTH LED [*C7]
LED state
ON OFF ON OFF ON OFF
ON
ON
CALL MAKING
Answer incoming call
End call
Voice dialling
Mute/UnMute Microphone
Reject incoming call
Transfer call to phone
Hold *
C1
Turn * dial
C6
Turn * dial
C5
LED Colour Indicating
BLUE Manual pairing mode (fast blink). Active until paired or time-out.
Automatic pairing mode (slow blink). Searching last paired device. Active until
BLUE
paired or time-out.
BLUE Pairing succeeded. Blue LED solid 5 seconds and then flashes.
RED Pairing failed. Red LED solid 5 seconds and then flashes.
BLUE Bluetooth active and paired. Blinking once every 30 seconds.
Press *
C2
Press *
C2
Hold *
C2
2 seconds
Press *
C3
Press *
C4
Press *
C4
x2
User instructions
2 seconds
(Bluetooth & side-tone)
units.
AUDIO PLAYBACK FROM PHONE
Play
Pause
Next track
Beginning of current track Press *
Beginning of previous track Press *
Scan track Forward
Scan track Backward
EN
Press *
C2
Press *
C2
Press *
C3
C4
x2
C4
Hold *
C3
Hold *
C4
4