The Clean Function - Lynx 4HT-429 X Instrucciones De Uso

Cleaning the catalytic
surfaces of the oven
Cleaning the oven floor,
Cleaning the glass cover
for the oven light

The Clean function

Cleaning levels
The rear wall of the oven is coated with self cleaning
enamel. The surface cleans itself while the oven is in
operation. Large splashes sometimes only disappear
after the oven has been used several times.
Never use oven cleaner on the back wall of the oven.
Should the enamel become slightly stained, this will
not affect its self cleaning properties.
Use hot soapy water or a vinegar solution.
It is best to use oven cleaner if the oven is very dirty.
Only use oven cleaner in a cold oven.
Never use oven cleaner on the self cleaning rear wall
of the oven.
Note:
Enamel is baked on at very high temperatures. This
can cause some slight colour variation. This is normal
and does not affect the function. Do not use coarse
scouring pads or strong cleaning agents to remove
such discolorations.
The edges of thin trays cannot be completely
enamelled. As a result, these edges can be rough.
Anti corrosion protection is guaranteed.
It is best to clean the glass cover with washing up
liquid.
The Clean function is a regeneration program. When
the oven's catalytic walls have not cleaned them
selves sufficiently, this function may be used to regen
erate them. They will then be completely effective
again.
Take all accessories and containers out of the oven.
Depending on the amount of baked on dirt, you can
select from the following cleaning levels:
Level 3 = 1 hour 15 minutes
Level 2 = 1 hour
Level 1 = 45 minutes
23