Site Selection - NetSpa ASPEN Manual De Instrucciones

3. INSTALLATION
WARNING : Spa installed on inadequately level surfaces are subject to leaking. forming irregulari-
ties or collapses. which can result in properly damage or serious injury for those in or around the spa
area!
CAUTION : Please choose your set-up area carefully as lawn and other desirable vegetation
undereath the ground cloth (if applicable) wil die. furthermore, try to avoid setting the ground cloth in
areas prone to aggressive plant and weed species, as they may grow trough the ground cloth.

3.1. Site selection

WARNING : Before proceed to installation your spa, please make sure that the future
location meets the following conditions :
• A level place in order to avoid any defect, hernia or leakage.
• Wide enough to support the pool and its pump unit.
• Able to support more than 500 kg/m².
• Sheltered from the sun and bad weather.
• Clean and free from sharp objects.
• Devoid of aggressive vegetation on the ground.
Failure to comply with these rules may result in property damage or personal injury.
A place with an awning
3.2. RCD test
WARNING: The RCD plug must be tested before each use..
Do not use if RCD test fails and see chapter 6.1.
1. Insert the plug into the
power outlet.
Grounding
You are recommended to use the services of a qualified electrician to ensure that the
spa is electrically grounded by using a copper conductor of at least 2.5 mm² cross
section.
24
Clean the place
2. Press the «RESET» button,
the indicator light turns red.
3. Press the «TEST» button,
the indicator light turns off.
A level place
4. Press the «RESET» button,
the indicator light turns red.
The RCD works properly.