Tectro R232TC Instrucciones De Uso página 21

Gently pressdown the wick adjustment knob
( Fig. K )
Gently pressdown the wick adjustment knob
Slowly release the knob
( Fig. K )
K
Gently pressdown the wick adjustment knob
Gently pressdown the wick adjustment knob
1 Gently press down the wick adjustment knob 2 until it stops at ignition position.
chamber
Gently pressdown the wick adjustment knob
( Fig. K )
(Fig. K)
Slowly release the knob ( Fig. K )
( Fig. K )
chamber
Slowly release the knob
Slowly release the knob
Slowly release the knob
2 Slowly release the knob 3 as soon as a flame is visible in the combustion cham-
chamber
chamber
ber D. (Fig. L)
chamber
After having ignited the heater, always check whether the combustion
L
chamber D is level, by sliding it slightly to the left and the right by its handle E
(Fig. F). This should be a smooth movement. If the combustion chamber is not
level, this will cause smoke and soot to develop.
F
D
BURNING OF THE HEATER
After you have ignited the heater, it will take 10 to 15 minutes before you can check
whether the heater is burning well. Too high a flame may cause smoke and soot,
whereas too low a flame causes smells. Fig. Q shows the minimum and maximum
permissible burning heights of the flame. The flame can be adjusted with the wick
adjustment knob B (Fig. M).
M
Burning that is too low may be caused by:
E insufficient fuel
E poor fuel quality
E insufficient ventilation
E wastage of the wick
N
E
SWITCHING OFF THE HEATER
Push the OFF-button A. The flame will extinguish after a little while (Fig. N).
F
MALFUNCTION, CAUSES AND SOLUTIONS
If any malfunctioning cannot be solved from the directions below, please contact
your dealer.
THE HEATER DOES NOT IGNITE
E The batteries are not positioned correctly in the holder.
Check (Fig. G).
E There is not enough power left in the batteries for the ignition.
Replace (Fig. G).
E You have run out of fuel from the tank or the wick has been replaced.
After having refilled and replaced the removable tank, wait for 30 minutes
before igniting the heater.
E You are pushing the button C with too much force.
Push it in less forcefully (Section C).
E The ignition coil K is defective.
Contact your dealer.
IRREGULAR FLAME AND/OR SOOT AND/OR SMELLS
E The combustion chamber D has not been positioned correctly.
Use the handle E to put it level, until you can easily slide it slightly to the left
and to the right and the chamber is level.
E You are using fuel which is past its 'use by' date.
Start every heating season with fresh fuel.
E You are using the incorrect type of fuel.
Refer to THE RIGHT FUEL (See Section 'What you need to know in advance').
E Dust has gathered in the lower part of the heater.
as soon as a flame is visible in the combustion
. ( Fig. L )
as soon as a flame is visible in the combustion
. ( Fig. L )
as soon as a flame is visible in the combustion
as soon as a flame is visible in the combustion
as soon as a flame is visible in the combustion
. ( Fig. L )
. ( Fig. L )
. ( Fig. L )
(fill the tank)
(contact your dealer)
(put window or door ajar)
(contact your dealer or replace the wick,
refer to section L
until it stops at ignition position.
until it stops at ignition position.
until it stops at ignition position.
until it stops at ignition position.
until it stops at ignition position.
4
21
R 125 E 1998 / 1999