Loading For Peel Mode - PATHFINDER 6057 Referencia Rápida

Loading for Peel Mode

1. Peel and discard the first four inches of labels from the
backing paper.
2. Hold the printer upright and gently press down on the label
deflector.
3. Feed the supply over the platen roller, over the peel bar, and
through the opening at the base of the label deflector.
4. Close the cover completely.
5. Hold the backing paper and push
the label deflector up until it snaps
into place.
6. Touch the Home key on the display, then select Load Supply,
Calibrate Stock.
Backing Paper
Opening
Label
Deflector
EN-5