KELCH TC100 Instrucciones De Servicio página 8

Brief instructions Micro / Pico LCD
1 Operation
EN
1.3 Saving Tools
Accepting tool target data from the measured tool
Position the tool on the crosshairs in the projector. Press the Tool memory (2) and then
the New SW button. Enter the Tool and press the downward arrow button. Accept
measured values via Import and Save.
Entering target values
Press the Tool memory (2) and then the New SW button. Enter the Tool and press the
downward arrow button. Enter the target values and press Save.
1.4 Separate Axis Measurements
The measurement of edges for which the maximum X and Z value cannot be recorded
simultaneously in the projector. (Edges with a large radius >2.5mm)
Move to the Z axis and then press the Z axis button (12). The display appears as below, the
value is frozen.
Move to the X axis. The current value of the X axis and the frozen value of the Z axis can be
read or printed.
Press the Z axis button (12). The display changes as shown. The display is frozen. Press the
axis button again to release the Z axis.
1.5 Incremental Measuring Mode
For tools with several edges, it is possible to determine tool data relating to the master edge.
This can be carried out for both axes or just for one.
Page 2 of 4
1048180 © Kelch GmbH 2012