Operation - cecotec CONGA 1790 ULTRA Manual De Instrucciones

ENGLISH
until it clicks to make sure they are properly fixed.
Fig. 22
Press the power switch located on the bottom part of the robot. Make sure the power switch
is turned On.
Fig. 23
Place the robot on the charging base and make sure the charging terminals on the robot match
with those of the charging base. Once the robot is properly placed, it will beep once and the
power button will light up If the light blinks orange, it means the battery is not completely
charged. To ensure maximum cleaning time, wait until the light switches to steady blue. This
will indicate the battery is fully charged and that the robot is ready to clean.
Fig. 24

3. OPERATION

Start cleaning
Long press the power button on the robot to activate the robot up.
Press the power button on the robot or on the remote control to start cleaning.
Note: If the robot runs out of battery during cleaning, it will automatically return to the charging
base. Once the battery is fully charged, the robot can start a new cleaning cycle.
Warning: If there is no good access to the charging base, the robot will not be able to return to
its charging position. In that case, once the robot has stopped, take it manually to the charging
base.
Pause
Press the power button on the robot or on the remote control to pause the cleaning process.
Press the power button on the robot or on the remote control to resume the cleaning process.
Fig. 25
Return to the charging base
Press the back home button on the robot or on the remote control in order to send the robot
to the charging base.
Turn off
Long press the power button to turn the robot off.
Fig. 26
Warning: The robot vacuum cleaner has a power switch located on its main body. If the robot
is not going to be used for long periods of time, it is suggested to switch it off. If the robot is
switched off, it will restore factory default settings as a safety measure. The robot will only
38