Teka INTEGRA 66750 Montaje Y Modo De Empleo página 24

In the case of the presence of panels and/or walls and/or lateral
wall units check that there is sufficient space to install the hood and
that access to the command panel is easy.
Operation
Always fully open the vapour catcher (A).
Fig. 9
Maintenance
Cleaning
Clean using ONLY a cloth dampened with neutral liquid detergent.
DO NOT CLEAN WITH TOOLS OR INSTRUMENTS. Do not use
abrasive products. DO NOT USE ALCOHOL!
Panel
Fig. 8
Attention! Hold the panel with both hands when dismantling
and re-mounting in position to avoid it falling and causing
damage to people or things.
Dismantling:
-pull the panel (FRONT SIDE) downward with decision,
-push to the left the small lever located on the right side of the
panel,
-unhook it from the back hinges.
Cleaning:
Clean the suction panel with the same frequency as the fats filter
using a cloth soaked in neutral liquid detergents.
Avoid the use of products containing abrasives. DO NOT USE
ALCOHOLS.
Light ON
Speed 1
Light ON
Speed 2
Light ON
Speed 3
Light ON
OFF
Speed 1
Light OFF
Speed 2
Light OFF
Speed 3
Light OFF
24
Montage:
The panel must be hooked at the back and fixed in front fitted into
the pins for the purpose on the surface of the hood.
Attention! always check that the panel is well fixed in its place.
Grease filter
Fig. 1-7
Traps cooking grease particles.
The grease filter must be cleaned once a month using non
aggressive detergents, either by hand or in the dishwasher, which
must be set to a low temperature and a short cycle. When washed
in a dishwasher, the grease filter may discolor slightly, but this
does not affect its filtering capacity.
To remove the grease filter, pull the spring release handle.
Charcoal filter (filter version only)
Fig. 6
It absorbs unpleasant odors caused by cooking.
The saturation of the charcoal filter occurs after more or less
prolonged use, depending on the type of cooking and the regularity
of cleaning of the grease filter.
In any case it is necessary to replace the cartridge at least every
four months.
The charcoal filter may NOT be washed or regenerated.
Circular charcoal filter
Apply one on each side as cover to both the shield grids of the
motor impeller, then turn clockwise.
For the disassembly, turn counter-clockwise.
Replacing lamps
The hood is equipped with a lighting system based on LED
technology.
The LEDs guarantee an optimum lighting, a duration up to 10
times longer than the traditional lamps and allow to save 90%
electrical energy.
For replacement, contact the technical service.