Descargar Imprimir esta página

Festool CS 70 VL Instrucciones De Montaje página 9

Ocultar thumbs Ver también para CS 70 VL:

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 12
Folding away the extension table:
Release rotary knobs (3.8).
Loosen knurled nuts (3.3).
Slightly raise the rear of the extension table and
remove ends of supports from slots.
Fold supports in crosswise.
Fold down extension table.
3
Ripping-cut fence CS 70 LA (1.3)
Precise sawing work with large work pieces is only
possible with a correctly fi tted ripping-cut fence CS
670 LA (Fig. 4).
The ripping-cut fence has separate clamps for the
front and rear edges of the table.
This prevents a lateral movement of the stop sur-
face.
The stop guide (4.7) can be fi tted to the stop rail
(4.5) as a high or low guide surface.
Rotate the stop guide by 90° and fasten to the cor-
responding guide grooves.
The following adjustments are possible with the
ripping-cut fence:
Handle (4.2): Clamp stop to front edge of table
Clamping lever (4.3): Clamp stop to rear edge of
table.
Clamping lever (4.1): Clamp fi ne adjustment.
Rotary knob (4.10): Stop adjustment with fi ne
adjustment
Rotary knobs (4.6): Clamp stop guide to stop
rail.
Open the following clamps fully in preparation for
fi tting the fence:
Clamp on front edge of table (4.2)
Clamp on rear edge of table (4.3). (clamping lever
in a vertical upright position)
Clamp on fi ne adjustment (4.21). (clamping lever
points towards switch)
Then slid the fence over the table from the right
so that the clamp jaws of the front and rear
clamps lie below the peripheral table clamping
edge (4.4).
The adjustment range for the fi ne adjustment an
be seen in the inspection window (4.9). Set a suf-
fi ciently large adjustment range for subsequent
adjustments with the rotary knob (4.10).
Then slide the fence according to scale close to
the desired cutting width and clamp by fl ipping
the clamping lever (4.1) approx. 180° to the fi ne
adjustment.
If the clamp is too weak the clamping lever can
be moved as follows:
Bring clamping lever into maximum clamping
position.
Release bolt which holds the clamping lever to
the axis.
Set clamping lever back by one division on the
hexagon.
Re-tighten clamping lever.
Set fence to exact size with fi ne adjustment using
rotary knob (4.10). The fence is hereby moved by
1/10 mm for every scale mark.
Tighten fence clamps (4.2 + 4.3) after fi nal adjust-
ment.
9

Publicidad

loading

Este manual también es adecuado para:

Cs 70 laCs 70 vb