Setpoints; Import Function Level, Device Info, Service And Touch Screen - Ecolab Versatronic Instrucciones De Servicio Breves

Parameters
Switch-off 1
Switch-off 2
Alarm tolerance
Alarm delay
1
) The unit displayed is dependent (by the execution of the plug-in card type of measurement) on the associated analysis slot.
10.5.3

Setpoints

Here, the set point of the controller channel can be changed.
Call: Device menuèParameterisationtarget valuesController target value 1 to 4 ètarget
value 1
Parameters
Target value X
10.6

Import function level, device info, service and touch screen

See operating instructions 417102269:
n Chapter 'function level' .
n Chapter 'device information' .
n Chapter 'Service' .
n Chapter 'Import touch screen' .
Selection /
setting
possibility Explanation
0 to 999.9 s Delaying the switch-on limit switch behaviour
[1](Proportional range = 0)
1 maximum amount of deviation without
0 to 999.9 ( )
triggering an alarm, when exceeding this
amount, the controller monitor triggers a
"Dosing alarm" from
0 to 9999 s The delay of dosing alarms allows for a
temporary violation of the alarm tolerance.
Selection /
setting
possibility Explanation
0.0000 - 99999 Target value adjustment
51
Device menu
Default
0.0 sec
0,0
0.0 sec
Default
Ci: 200.00
mS/cm
Cr: 200.00
uS/cm
pH: 7,00
ORP: 300.00
mV
Cl: 10.000 mg/l
Cd: 0.3000 mg/l
Pa: = 1000,0
mg/l
417102279 Rev. 2-08.2020