Restore Default Values - Fermax Cityline DUOX PLUS Manual De Instalador

RESTORE DEFAULT VALUES: Reset
The DUOX PLUS amplifier has a 'Reset' function which can be
used to restore programmed default parameters.
RESET Mapping (call button code)
1. Reset amplifier: remove power.
2. Press the SW1 button, connect the power supply and maintain
the SW1 button pressed 5 seconds until you hear the reset
confirmation sound: beep-beep.
Lock-release times / Configuration of parameters
To change the lock-release times.
To configure the panel's different parameters.
See Voice-assisted configuration. Available via the QR codes on
the back of the amplifier, or at www.fermax.com.
RESET to default parameter values (via keypad)
You can Reset the parameters to the factory default values. For
this you must temporarily connect a keypad (ref. 7439) to enter
the numeric values. Download the Direct Panels Programming
Manual, cod. 97701 at www.fermax.com.
Pag 33