Description; Physical Description; Technical Description; Lcd Screen/Control Keypad - ACTEON I-Endo Dual Manual De Uso

Maintenance:
- Before and after each use, your device must be disinfected with products recommended by the
manufacturer.
- Before each procedure, it is essential to make sure that the accessories to be used have been cleaned
and disinfected.
Accessories:
- The device can only accept accessories designed by the manufacturer for the particular use for which
they are intended.
- Use of accessories from other manufacturers is a potential hazard for you or your patients.
Repair:
- Do not repair or modify the device without prior authorization from the manufacturer.
- In the case of a fault, contact the supplier of your device. Do not use unauthorized repairers, who
might make your device dangerous for you and your patients.
If you have any doubt, contact an approved dealer or our customer support department:
• www.acteongroup.com
• E-mail: satelec@acteongroup.com.
III – DESCRIPTION

3.1 PHYSICAL DESCRIPTION

1. Electronic Control Console (Fig. 1 – 1)
2. Micro Motor (Fig. 1 – 2)
3. Foot Control (Fig. 1 – 3)
4. Power Supply (Fig. 1 – 4)

3.2 TECHNICAL DESCRIPTION

a. LCD screen/control Keypad
The I-Endo Dual is adjusted by applying reasonable pressure to the keypad buttons.
1. With "MODE" buttons, the operator can easily switch from "F+R" and "ROTATING"
movement. The Display change accordingly. (Fig. 2 – 1)
2. Scrolls Programs (1 -10 ). (Fig. 2 – 2)
3. Set the handpiece ratio. (1:1 - 6:1 - 16:1 - 20: 1- 32:1). (Fig. 2 – 3)
4. Performs a self-calibration of handpiece and micromotor. (Fig. 2 – 4)
5. Switches ON and OFF motor (if enabled). (Fig. 2 – 5)
6. +/-: Set motor rotation speed (value in rpm). (Fig. 2 – 6)
7. +/-: Set motor torque (value in Ncm). (Fig. 2 – 7)
8. FWD/REV: clockwise and anti-clockwise. (Fig. 2 – 8)
9. REV type: Stop, Auto reverse, Special Auto Reverse. (Fig. 2 – 9)
10. FWD°: Scroll up and down from 10° to 360 ° in forward. (Fig. 2 – 10)
11. REV°: Scroll up and down from 10° to 360 ° in Reverse. (Fig. 2 – 11)
12. Footswitch inlet. (Fig. 2 – 12)
13. Motor Receptacle. (Fig. 2 – 13)
Information required by the user is displayed on the LCD screen.
9