Setting Up The Module In Ip_Axes - Fermax IP_AXES 4+ Manual De Instalador

Cod. 97846 V05_17

SETTING UP THE MODULE IN IP_AXES

To configure your IP_AXES software, you will need the module identifier. This is printed on a sticker
of the housing (e.g. ID: 00001). Make a note of this number.
Click on the "Technical" button and then "Site configuration".
Under the unit your module is connected to, click on "Extension modules" and then "Add module
IP_AXES 4+".
The following window will then be displayed:
3200291
Enter the identifier of your module
Configure Fail-soft mode operation (loss of connection between the
module and the unit)
Page 18/29