Cavist 166 Manual De Usuario página 6

For easy access to the bottles stored, pull the shelves out approximately 1/3. The shelves are
designed with an emergency stop to prevent them being removed too far when loaded.
Using Your Wine Cooler
Before switching on
o Make sure that it has been installed by a suitably qualified person, as per the information
contained in the installation instructions.
o After delivery, wait for eight hours before connecting the appliance to your mains supply. This
will allow any refrigerant gasses that may have been disturbed during the transportation process
to settle.
o The outside of the appliance and the removable accessories contained within it, should be
cleaned with a solution of liquid detergent and water.
o The interior of the appliance should be cleaned with a solution of sodium bicarbonate dissolved
in lukewarm water.The interior and accessories should be thoroughly dried, after the cleaning
process has been completed.
o There can be an odour when you first switch on the appliance. It will lessen as the appliance
starts to cool.
During first use
IMPORTANT: When you use the wine cooler for the first time or restart the appliance after it has
been turned off for a long time, there could be a few degrees variance between the temperature
you select and the one indicated on the LED display. This is normal and it is due to the length of
activation time. Once the wine cooler has been running for a few hours everything will be back to
normal.
o When you first switch on the appliance, the compressor will run continuously until the wine cooler
reaches a cool enough temperature.
o During this period of time, you should try not to open the door frequently or place bottles inside
of the appliance.
o If the unit is switched off or unplugged, you must allow at least 5 minutes before restarting the
appliance or reconnecting it to your mains supply.
Switching on the appliance and setting the temperature
To switch the appliance on, press the button
again, press and hold the power button for 5 seconds.
o When you press the TEMPERATURE SET BUTTONS
display will indicate the factory preset temperature.
o Press the TEMPERATURE SET BUTTONS
decrease 1°C OR 1°F until the temperature you want.
and hold 5 seconds, turn the appliance off
or
or once. The display will increase or
for the first time, the LED