Possible Uses; Package Contents; Installation Notes - Siemens HiPath Instrucciones De Montaje

Possible uses

Possible uses
The OpenStage PhoneAdapter gives users an additional U
HiPath communication platform. It can be used to connect up a second OpenStage phone
or an analog device to the telephone network.
Advantage:
Two devices can be connected to the phone network using a single line. No extra cables
are necessary - extremely easy to install.
The PhoneAdapter requires its own external power supply unit.
Some system devices attached to the PhoneAdapter will require their own power
supply unit, see below for details.
The following terminals can be connected to the PhoneAdapter:
• U 0 system telephone:
p
OpenStage 20 T
OpenStage 40 T
OpenStage 60 T and 80 T (require their own power supply unit)
optiPoint 500 (must be connected to U
Optiset E (must be connected to U
• Analog device:
Phone with MFV tone dialing (e. g. Euroset 5020 or a cordless phone such as Gigaset
A160), a Group 3 fax Gr. 3 or a modem.

Package contents:

• 1 OpenStage PhoneAdapter
• 2 connection cables (6-meter)

Installation notes

Use only the supplied cables to attach devices to the OpenStage PhoneAdapter. Cables to
connected terminals must not exceed a length of 10 meters.
The PhoneAdapter can be used in the following configurations only:
• One U 0 system telephone (U
p
• Two U 0 system telephones (U
p
• One U 0 system telephone and one analog terminal (U
p
It is not possible to operate two U
12
0 Slave output socket)
p
0 Slave output socket)
p
0 Master)
p
0 Master, U 0 Slave)
p p
0 system telephones and one analog device.
p
0 or analog connection to the
p
0 Master, a/b)
p