Install The Hood - JENN-AIR JXT-B Serie Manual De Uso

1. Rest the back cavity of the hood on the wood mounting
strip.
CAUTION: Hold the hood until it is completely
!
secured to the wood mounting strip.
Secure hood to wood strip with (4) screws #8 - 3/4" (for
30" and 36" width hoods) or (6) screws (for 48" width hood)
provided at location shown. Drill (2) 3/16" size holes into
the drywall for wall anchors through the existing holes in
the inside hood back in the locations shown. Then install
the (2) wall anchors and attach the hood to these anchors
with the remaining #8 - 3/4" screws and the (2) washers
provided.
2. Attach transition (if required) to blower rough-in plate.
Refer to page 6 for available models.
Use duct tape to make all joints secure and air-tight.
NOTE
Model H325B blower plate connects directly to 7" round
duct without a transition.
3. Run power cable to installation location. Refer to the
instructions included with the selected blower / rough-in
kit (sold separately) for details on installing the rough-in
plate. Install the rough-in plate so that the wiring box is
located on the right side as you are facing the hood.
For ducting through back of hood, remove existing plate
from inside back of hood and attach to inside top of hood
to cover hole. Secure to threaded studs with same (4)
nuts.
For ducting through top of hood, existing plate remains in
place on inside back of hood.
Connect ducting to transition or rough-in plate as you are
installing the rough-in plate. Use duct tape to make all
joints secure and air-tight.

INSTALL THE HOOD

HD0064
HD0049
HD0063
9
Top of hood (inside view)
Mounting screw locations
Back of hood (inside view)
Wall anchor locations
Plate on top of hood
Locknuts
Rough-in plate on back of
hood
Locknuts
Wiring
cover