LaserLiner PowerCross-Laser 8 S Manual De Instrucciones página 17

Slope function up to max. 3°
4
Activation of the slope function deactivates the automatic sensor. In addition,
press the auto/man button until the LEDs of the x-axis (15) light up. Motor-
driven adjustment of the slope can now be carried out. Hold the plus or
minus buttons down continuously to adjust slope. When the lasers blink, the
maximum slope range has been reached. The X/Y button (pressed briefly) is
used to switch between axes. Refer to the illustrations below.
For the slope function, laser lines are no longer aligned to the
horizontal or vertical plane. This is a specific peculiarity of adjusted
!
laser lines. To reinstate horizontal or vertical levelling, deactivate
the slope function. To do so, switch the device off and back on
or keep the auto/man button pressed until the laser lines move
automatically.
Horizontal levelling adjustment up to a max. of 3° (X, Y axis)
5
Adjustment of the X axis up to a max. of 3°
The LEDs of the X-axis (15) light up in green.
Adjustment of the Y axis up to a max. of 3°
The LEDs of the Y-axis (16) light up in red.
PowerCross-Laser 8 S
17
GB