Technical Data; Error Codes - LaserLiner DistanceCheck Manual De Instrucciones

• Carpeting, upholstery or curtains will not reflect the laser optimally.
Measure to flat surfaces.
• Measurements made through glass (window panes) can falsify
measurement results.
• An energy-saving function switches the device off automatically.
• Clean with a soft cloth. Water may not be allowed to penetrate the
housing.

Technical Data

Inside measurement range
Precision (typical)*
Laser class
Laser wavelength
Power supply
Dimensions (W x H x D)
Weight (incl. batteries)
Automatic switch-off
Operating temperature
Storage temperature
* measuring distance up to 10 m with strongly reflective target surface
and at room temperature. The measurement deviation may increase by
+/-0.2 mm/m for weakly reflective target surfaces.

Error codes:

Calculation error
Received signal too weak
Received signal too strong
Measuring time too long
Ambient light level too high
Temperature is too high: > 40°C
Temperature is too low: < 0°C
Hardware fault
EU directives and disposal
This device complies with all necessary standards
for the free movement of goods within the EU.
This product is an electric device and must be
collected separately for disposal according to
the European Directive on waste electrical and
electronic equipment.
Further safety and supplementary notices at:
www.laserliner.com/info
(Subject to technical changes without notice. 02.16)
0.05 m - 20 m
± 2 mm / 10 m
2 < 1 mW
645-655 nm
2 x AAA 1.5 Volt batteries
118 x 37 x 26 mm
84 g
30 sec laser / 3 min device
-10°C – 40°C
-20°C – 70°C
DistanceCheck
11
GB