Prior To First Use; Switching On And Off - tomado TAF5001B Instrucciones De Uso

Before using the appliance for the first time, you should proceed as follows: carefully unpack the hot air fryer and remove all
packaging material and any promotional stickers. Keep the packaging (plastic bags and cardboard) out of the reach of children.
After unpacking the appliance, check it for external damage that may have occurred during transport. Place the hot air fryer on
a sturdy, flat and heat-resistant surface.
The buttons used for operating the hot air fryer, are touch controls and an easy control rotary knob. Carefully touch the touch
controls with a finger to activate. Each time the touch control is touched and the rotary knob is turned, you can hear a sound signal.
STANDBY
As soon as you insert the plug in the socket, the hot air fryer is in the standby position. The standby key
In the following situations, the hot air fryer automatically switches to the standby position:
• when you insert the plug in the socket
• when the set time has elapsed
• when you press the standby key
SWITCHING ON AND OFF
Switch on the hot air fryer with the standby key
• The hot air fryer only functions if the basket has been placed in the pan correctly.
• As soon as the set time has elapsed, the hot air fryer automatically switches to the standby position: The fan does continue
to run in order to allow the hot air fryer to cool down. After approximately 20 seconds, 5 beeps will sound and the fan symbol
is switched off.
• Attention: during cooling it is not possible to operate the display.
PRIOR TO FIRST USE
Check that the voltage corresponds with what is stated on the information plate and insert the plug in an earthed socket.
The heating element is provided with a protective layer that must be removed prior to first use. This is done by setting the
hot air fryer to the maximum position for approximately 10 minutes without any food in the appliance. A little smoke may be
generated due to the protective layer being burnt off the heating element. Therefore ensure sufficient ventilation in the room.
After removing the protective layer you can switch off the hot air fryer.
Remove the plug from the socket. Allow the hot air fryer to cool down properly and clean loose components prior to actually
using the hot air fryer. Clean the basket and pan with warm water, a mild washing-up liquid and a soft sponge. Tip: these
components may also be cleaned in the dishwasher.
Clean the interior and exterior of the appliance with a damp cloth.
This fryer works with hot air. Do not fill the pan with oil or frying fat.
• Place the hot air fryer on a heat-resistant flat surface.
• Properly place the basket in the pan.
• Place the pan in the hot air fryer.
CAUTION! Properly place the pan in the hot air fryer, otherwise it will not function.
Do not fill the pan with oil or other liquids.
Place nothing on top of the appliance.
Do not place anything over the air inlet openings. This will disrupt the air circulation and will have a negative effect on the
frying result.
SETTING TEMPERATURE AND TIME
keys to set the temperature °C and the time MIN. The display changes every 5 seconds if no key is operated.
Use the and

PRIOR TO FIRST USE

for 4 seconds.
.
EN - 17
lights up.