ESTEBAN CMP 142 Instrucciones De Uso página 8

2
A
B
Maximum
level 250ml
D
C
3
STAGE 3
Use the remote control to start/stop your diffuser or to adjust the diffusion cycles (long press: 2 seconds):

: Start on 120min cycle
: Increase duration of diffusion cycles
: Reduce duration of diffusion cycles
60 min.
You can stop the diffusion at any time by pressing the button
• Thanks to the automatic stop system, you can enjoy the perfumed atmosphere without worrying about the diffuser.
• During the diffusion, the height of the mist may vary.
• When the appliance is operating, make sure not to put any obstacle above the appliance that could hamper the release
of the mist and not to remove the upper parts in order to avoid any splashing.
8
STAGE 2
• Place the diffuser on a flat and stable surface away from the edge.
• Remove the upper parts "A" and "B". Pour water at room temperature into the container "C",
using the maximum levels shown in the tank.
Do not exceed the maximum level of 250ml. (Warning: the diffuser does not work if the
water level is too low or higher than 250ml).
• Do not pour hot water into the container (risk of damage of sensitive components).
• Add a few drops of ESTÉBAN refresher oils or essential oils: 15 to 20 drops depending on the
expected intensity (the harshest and most viscous essential oils should not be used as they may
damage your diffuser).
-  Do not pour drops of refresher oils or essential oils into the
container if there is no water in it as this risks damaging the device.
- Wipe up any drops that may accidentally have fallen outside the container.
- An excess of refresher oils or essential oils could prevent the diffusion and damage the diffuser.
• Place the upper parts "B" then "A" back on the diffuser base.
• Do not move the diffuser once you have filled it.
120 min.

You can also adjust the diffusion cycles manually:
• Press the "ON/OFF" button (long press: 2 seconds):
1 press, the first blue light "F" lights up, diffusion starts and stops automatically after 60 min.
st
2 press, the second blue light "G" lights up, diffusion starts and stops automatically after
nd
120min.
3 rd press, the third blue light "H" lights up, NON STOP diffusion starts and stops automatically
after a variable length of time depending on the energy supply and the water level (for
more details, see the NON STOP durations table below).
The mist may take a few seconds to become visible after lighting, and will be optimised after around
15 minutes.
Duration table* in NON STOP mode
WATER LEVEL
250ml (max)
(*durations given as an indication only and may vary according the use conditions)
4 press, lights go out, diffusion stops.
th
NON STOP
FULL BATTERY MAINS SUPPLY
≈3.5h

at the centre of the remote control.
≈12h
OP
CL
Afte
by f
• sw
 T
AN
• re
• em
pla
elec
• cle
abso
up l
that
The
• us
out
• us
• as
stro
RE
If th
Th
or
No
sw
Mi
in
Ins
Th
no
Sho
Th