English; Ce89E Chanfering Planer; Changing Blades; Technical Characteristics - Virutex CE89E Manual De Instrucciones

E N G L I S H
CE89E CHAMFERING PLANER
Important
Read these OPERATING INSTRUCTIONS
and the attached GENERAL SAFETY
INSTRUCTIONS LEAFLET carefully before
using the machine. Make sure you have
understood them before operating the
machine for the first time.
Keep both sets of instructions for any
future queries.
1. SAFETY INSTRUCTIONS FOR
USE OF THE PLANER
Read carefully the GENERAL SAFETY IN-
STRUCTIONS LEAFLET, which is included
in the machine documentation.
1. Before starting up the machine make sure that
the supply voltage is the same as that shown on the
specification plate.
2. Always keep hands clear of the cutting area, and
always hold the machine using the grips.
3. Always use original VIRUTEX blades. Never use blunt
or damaged blades or blades of the wrong size or in
poor condition.
Always use the original VIRUTEX blade holders and blade
supports mounted on the machine. If necessary, replace
them with original VIRUTEX parts.
4. It is necessary to work with dust collection in order to
prolong the life of the blades and prevent any breakages.
5. Avoid cutting nails. Check the work surface before
planing.
6. Wait until the machine has come to a complete stop
before putting it down or storing it.
7. Wear earplugs when using the machine (see chapter 10)

2. TECHNICAL CHARACTERISTICS

Imput Power.................................................................700 W
Motor............................................................................50/60 Hz
No load speed..........................................................16,500 /min
Cuts per minute............................................................33,000
Cutting width 90°..........................................................25 mm
Cutting depth...........................................................0-12,5 mm
Weight............................................................................3.3 kg
Weighted equivalent continuous
acoustic pressure level A..................................................89 dBA
Acoustic power level A....................................................100 dBA
Uncertainty...................................................................K = 3 dbA
Wear ear protection!
Vibration total values.............................................a
Uncertainty.................................................................K: 1.5 m/s
3. STANDARD EQUIPMENT
Contained in the transportation case you will find the
following elements:
1. Planer CE89E; 2. Dust collector connection; 3. Key for
securing the blades
4. GENERAL DESCRIPTION
The CE89E planer is equipped with replaceable, twin-use
blades of hard metal, and a safety switch with inverse lock-
ing, which prevents accidental start up of the machine.
The machine is equipped with a dust collector connec-
tion which can be used for connection to our AS182K,
AS282K dust collector or any industrial equivalent via
the STANDARD DUST COLLECTOR ATTACHMENT (ref.
6446073). For assembling the dust collector connection,
remove the chips outlet guide A (Fig. 1) using screw B
and fit the dust collector connection in its place.
5. REGULATING THE CUT
Turn knob C (Fig. 2) until the required depth is reached

6. CHANGING BLADES

Changing and adjustment of blades
Disconnect the machine from the mains
before carrying out this operation.
Turn knob C (Fig. 2) until the front part of the base
is completely free. Loosen screws D (Fig. 3) and move
the blade sideways to remove it from the blade-holder
cartridge. Insert the new blade in the cartridge and
tighten screws D.
The blade-holders on the machine are perfectly adjusted
and no further adjustment is needed. If adjustment
becomes necessary this is carried out by screws F. The
blades supplied by Virutex are reversible (double-edge).
Ensure that screws D are well tightened
up before restarting work with the
machine.
Only use Virutex original spares for any spares needed
for the Blade-holder system.
7. CHANGING THE TRANSMISSION BELT
: <2.5 m/s
2
h
2
5