Installing The Batteries In The Remote Control; Front Panel - Ltc Audio ATM6000BT Manual De Uso

Number buttons from 0-9: Press to select directly a title/track number
10-/10+: Press to skip forwards or backwards in steps of 10

INSTALLING THE BATTERIES IN THE REMOTE CONTROL

•
Place the remote face down on a flat surface.
•
Push the compartment cover into the direction of the arrow.
•
Slide the battery compartment open.
•
Remove the old battery and install the new one (CR2032) with the plus (+) symbol facing up.
•
Gently slide the battery compartment closed. It locks automatically.
RECOMMENDATIONS FOR BATTERIES
This symbol indicates that used batteries should not be disposed of with household waste but deposed correctly in
accordance with your local regulations. Batteries shall not be exposed to excessive heat such as sunshine, fire or the
like. When the internal batteries are not to be used, remove them to avoid damage caused by battery leakage or cor-
rosion.
ATTENTION: Danger of explosion if battery is incorrectly placed. Only replace by the same or equivalent type.
The supplied remote control contains a button cell. In case of ingestion, it might cause serious internal burns within only 2
hours that might lead to death. Keep new and old batteries out of the reach of children. If you are in doubt whether the
batteries have been swallowed or introduced into any other part of the body, contact immediately a doctor.
Features
•
USB/SD card input
•
Spectrum Screen Display
•
2x microphone inputs with Echo & Volume control
•
FM tuner
•
Bluetooth function

Front panel

2 3 4
1 7 8
1. POWER: Press this button to power ON or OFF the unit
2. Play/Pause: Press this button to play the signal from USB/SD, Bluetooth. Press again to pause
3. Previous: Press this button to go back to the beginning of the current track or move to the previous track.
4. Next: Press this button to move to the next track.
5. Repeat/Random /
RANDOM. The default setting is repeat all.
6. Input: Press this button to cycle through the various inputs.
7. USB: Connect your USB flash drive here
8. SD: Connect your SD card here
9. MP3 input: Connect your MP3 here
10. LOUDNESS: Press this button to adjust the loudness
11. EQ MODE: Press this button to cycle through the pre-set equalizer modes.
12. Audio Function: Press this button to switch the control mode between bass, treble & master volume
13. MIC1 & MIC2: Connect your microphones here
14. MIC VOL: Use this knob to adjust the microphone volume
15. ECHO: Use this knob to adjust the echo of microphone.
16. Headphone Output: Connect your headphone here
17. Master Volume: Use this knob to control the master volume
ATM6000BT (10-7051)
5 6
9
: Press this button to select the repeat mode between REPEAT ONE, REPEAT ALL,
www.ltc-audio.com
10 11 12 14 15
13
17
16
3