FLAEM Lella la coccinella Manual De Instrucciones página 11

6. Turn on the device using the switch (A1) and then breathe in and exhale deeply.
7. When the treatment is finished, shut off the device and unplug the power cord.
WARNING: If after the therapy session moisture accumulates in the tube (B), remove the tube from the nebulizer
and dry it using the device's compressor fan; this operation will prevent mold from forming inside the tube.
NASAL WASH RHINO CLEAR®
Before each use, wash your hands thoroughly and sanitize RHINO CLEAR® as described in section
"CLEANING SANITIZATION DISINFECTION". The NASAL WASH SYSTEM and accessories are for personal
use only to avoid potential risks of transmitting infection. During the application it is recommended to be
adequately protected against dripping.
1) Plug the power cord (A6) into the socket (A5) and plug the power cord into a power socket corresponding to
the voltage of the unit. This must be positioned so that it is not difficult to make the disconnection from the
mains.
2) Insert the atomizer (C5.3) into the nebulization chamber (C5.4.1). Place the solution (max
10 ml) in the nebulizing chamber (C5.4.1).
3) Apply the separator (C5.2) verifying that the arrow on the shower body is aligned with the
separator (Pic. B). Then, insert the correct adapter for your age, or the most appropriate to
fit the size of your nostrils (C5.1A/C5.1B/C5.1C).
4) Connect the RHINO CLEAR® device through the tube (B) and the fitting (C6).
5) Turn on the device using the switch (A1).
6) Place the device close to the nose and gently insert the adapter nosepiece into one nostril.
7) During treatment it is preferable to hold the other nostril closed, where the shower is not
applied, by applying light finger pressure.
8) Run the shower holding down the manual dispensing button (C5.5) during the inhalation phase and release
it before exhaling; at this stage, to help expel the mucus, blow gently through the nostril treated directly into
the RHINO CLEAR®.
9) Repeat from Step 6 to Step 8 for the other nostril, trying to evenly distribute the solution between the two
nostrils.
10) When used on children or other dependent people, or in any case when there are problems in coordinating
the various phases of paragraph 8), we recommend to run the application alternating the nostrils about 20
seconds each, with pauses required to expel the mucus.
11) The operations described in the preceding paragraphs is useful for nasal cleaning using physiological
solutions. The treatment with drugs is advisable after a first cleaning with physiological solution in order to
achieve a more effective distribution of the drug on the nasal mucosa.
12) When the treatment is finished, shut off the device and unplug the power cord. Clean it following the
instructions provided in the "CLEANING SANITISATION DISINFECTION" paragraph.
CLEANING SANITISATION DISINFECTION
Switch the device off and disconnect it from the power supply before proceeding with any cleaning operation.
CLEANING THE DEVICE (A) AND THE TUBE'S OUTER SURFACE (B)
Only use a cloth with antibacterial detergent (non-abrasive and with no solvents of any kind)
ACCESSORIES
We recommend personal use of accessories to avoid any risk of spreading the infection.
Disassemble the accessories as described below:
C1 - Open the nebulizer by turning the upper part (C1.3) anticlockwise, remove the nozzle from the upper part
(C1.3) and then disassemble it as shown in the "Assembly diagram" in section C1.2.
C5 - Disassemble it as shown in the "Assembly diagram" in section C5.
SANITISATION AND DISINFECTION
SANITISATION
Before and after each use, sanitise the nebuliser cup and the accessories, choosing one of the methods described
below.
method A: Sanitise accessories C1.1-C1.2-C1.3-C1.4-C2-C3-C4-C5.1A-C5.1B-C5.1C-C5.2-C5.3-C5.4-C5.5-C6
under potable hot water (approximately 40°C) with a gentle, non abrasive dish detergent.
method B: Sanitise accessories C1.1-C1.2-C1.3-C1.4-C2-C3-C4-C5.1A-C5.1B-C5.1C-C5.2-C5.3-C5.4-C5.5-C6
in the dishwasher with a hot cycle.
method C: Sanitise accessories C1.1-C1.2-C1.3-C1.4-C2-C3-C4-C5.1A-C5.1B-C5.1C-C5.2-C5.3-C5.4-C5.5-C6
by immersing them in a solution of 50% water and 50% white vinegar, then rinse thoroughly under potable hot
water (approximately 40 °C).
If you want to also perform the cleaning for DISINFECTION, jump to the DISINFECTION paragraph.
After having sanitised the accessories, shake them vigorously and place them on a paper towel. Alternatively, dry
them with a jet of hot air (for example, a hair dryer).
9
C5.4.1