Replacing The Power Cable; Disposal And Recycling; Cleaning And Maintenance - EINHELL TH-VC 1820 S Manual De Instrucciones

Anleitung_TH_VC_1820_S_SPK8__ 19.11.12 16:11 Seite 10
GB
6. Operation
Important!
Switch off the equipment if liquid or foam is emitted
with the exhaust air when wet vacuum cleaning.
6.1 On/Off switch (Fig. 1)
Switch position 0: Off
Switch position I: On
6.2 Dry vacuuming
Use the dirt bag (14) and the additional filter (18) for
dry vacuuming (see point 5.2).
Always ensure that the filters are perfectly secure.
6.3 Wet vacuuming
For wet-vacuuming, use the foam filter (15) (see
point 5.2).
Check that the filter is securely fitted at all times.
Important.
When wet vacuuming, the floating safety switch (5)
turns off the wet and dry vacuum cleaner
automatically when the maximum level is reached.
Important!
The wet and dry vacuum cleaner is not suitable for
the vacuuming of combustible liquids.
For wet vacuuming, use only the supplied foam filter.
6.4 Blowing
Connect the suction hose (10) to the blow connector
(9) on the wet and dry vacuum cleaner.

7. Cleaning and maintenance

Important!
Always pull out the mains power plug before starting
any cleaning work.
7.1 Cleaning
Keep all safety devices, air vents and the motor
n
housing free of dirt and dust as far as possible.
We recommend that you clean the equipment
n
immediately after you use it.
7.2 Cleaning the appliance head (3)
Clean the appliance regularly with a damp cloth and
some soft soap. Do not use cleaning agents or
solvents; these may be aggressive to the plastic
parts in the appliance.
10
7.3 Cleaning the container (7)
The container can be cleaned with a damp cloth and
some soft soap or under running water, depending
on the amount of dirt.
7.4 Cleaning the foam filter (15)
Clean the foam filter (15) with a little soft soap under
running water and allow it to air-dry.
7.5 Servicing
At regular intervals and before each use, check that
the filters in the wet and dry vacuum cleaner are
securely fitted.

8. Replacing the power cable

If the power cable for this equipment is damaged, it
must be replaced by the manufacturer or its after-
sales service or similarly trained personnel to avoid
danger.

9. Disposal and recycling

The equipment is supplied in packaging to prevent it
from being damaged in transit. The raw materials in
this packaging can be reused or recycled. The
equipment and its accessories are made of various
types of material, such as metal and plastic.
Defective components must be disposed of as
special waste. Ask your dealer or your local council.