cascade corporation 35A Manual Del Usuario página 8

I
NSTALLATION
Install forks
4
Remove capscrew from fork loading slot in center
of lower carriage bar. Use pallet or blocks as
necessary to raise forks to installation height. Keep
feet clear of forks when installing. Tighten capscrew
to a torque of 165 Nm.
5
Check Sideshifter bearing lubrication
Bearings are prelubed at the factory with break-in
grease. No additional lubrication is required
during installation.
NOTE: After 600 hours of operation, sideshifter
bearings should be lubricated with general-purpose
chassis grease.
7
Fork Loading
Slot Capscrew
Fork
Locking
Pin
SS1007.eps
Upper bearing grease areas
Lower bearing grease areas
Front View
WARNING: If the fork locking pin is not
fully engaged, the fork could become
disengaged from the carriage.
SS0953.eps
6812836 EN