Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
Depending on the type of car, be sure to insulate the
unused leads with electrical tape for safety.
Do not connect this cable when the steering wheel
remote control is not used.
Consulting the dealer or an experienced technician
for help is recommended.
When using the wired remote control
1
To enable the wired remote control, set [STR
CONTROL] in [STEERING] to [PRESET].
Installation
Mounting the unit in the dashboard
For Japanese cars, see "Mounting the unit in a
Japanese car" (page 13).
Mounting the unit with an installation kit
(not supplied)
You can use a commercially available double DIN
installation kit. Choose an installation kit with the
following panel frame size.
Larger than 172 mm × 97 mm (6
h), with an inner corner radius of less than 0.5 mm
(
1
/
in).
32
Note
Be sure to use the mounting screws .
Larger than
97 mm (3
7
/
in)
8
Larger than
172 mm (6
7
/
in)
8
Installation kit (not supplied)
7
/
in × 3
7
/
in) (w/
8
8
To dashboard/center console
Mounting the unit in a Japanese car
You may not be able to install this unit in some
makes of Japanese cars. In such a case, consult your
Sony dealer.
Bracket
Parts supplied with
your car
When mounting this unit to the preinstalled
brackets of your car, use the mounting screws in
the appropriate screw holes based on your car:
T for TOYOTA and N for NISSAN.
Note
To prevent malfunction, install only with the mounting
screws .
Resetting the unit
For details, see "Resetting the Unit" (page 6).
Fuse replacement
When replacing the fuse, be sure
to use one matching the
amperage rating stated on the
original fuse. If the fuse blows,
check the power connection and
replace the fuse. If the fuse blows
again after replacement, there
may be an internal malfunction. In such a case,
consult your nearest Sony dealer.
To dashboard/center console
Bracket
Fuse (10 A)
13
GB
Publicidad
Tabla de contenido
