Makita DJN161 Manual De Instrucciones página 6

Permissible cutting thickness
► 1. Gauge for cutting stainless: 1.2 mm (3/64")
2. Gauge for cutting mild steel: 1.6 mm (1/16")
3. Notch
The thickness of material to be cut depends upon the tensile
strength of the material itself. The groove on the die holder acts
as a thickness gauge for allowable cutting thickness. Do not
attempt to cut any material which will not fit into this groove.
Cutting line
The notch in the die holder indicates your cutting line.
Its width is equal to the cutting width. Align the notch to
the cutting line on the workpiece when cutting.
Switch action
► 1. Slide switch
CAUTION:
• Before inserting the battery cartridge into the
tool, always check to see that the slide switch
actuates properly and returns to the "OFF"
position when the rear of the slide switch is
depressed.
• Switch can be locked in "ON" position for ease
of operator comfort during extended use. Apply
caution when locking tool in "ON" position and
maintain firm grasp on tool.
To start the tool, slide the slide switch toward the "I
(ON)" position. For continuous operation, press the
front of the slide switch to lock it.
To stop the tool, press the rear of the slide switch, then
slide it toward the "O (OFF)" position.
Indication lamp with multi function
1
2
3
► 1. Indicating lamp
Indication lamps are located in two positions.
—
—
1
ASSEMBLY
CAUTION:
•
Removing or installing the punch
and die
► 1. Die holder 2. Die 3. Bolts 4. Hex wrench
6 ENGLISH
Battery cartridge replacing signal
— When the battery power is almost used up
during operation, the red lamp lights up and
the tool stops immediately. Replace the
battery with fully charged one when the red
lamp lights up.
Accidental re-start preventive function
— Even if the battery cartridge is inserted on
the tool with the slide switch in the "I (ON)"
position, the tool does not start. At this time,
the lamp flickers slowly and this shows that
the accidental re-start preventive function is
at work.
— To start the tool, first slide the slide switch
toward the "O (OFF)" position and then slide
it toward the "I (ON)" position.
Always be sure that the tool is switched off and
the battery cartridge is removed before carrying
out any work on the tool.
3
1
1
2
4