Beper BC.001 Manual De Instrucciones página 12

Tabla de contenido

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 31
Espresso machine Use instructions
2. Set steel mesh into metal funnel, make sure the tube on the funnel aligns with groove in the
appliance, then insert the funnel into the appliance as indicating of "INSERT" mark, and you can fix
them into coffee maker firmly through turn it anticlockwise until it is fully locked.
3. Place an espresso cup (yourself cup) on removable drip plate.
4. Then connecting the appliance to power supply source. Make sure the knob is on the "
" posi-
tion.
5. Press the ON/OFF switch, the power indicator (red) will be illuminated, make sure the steam but-
ton is on the higher position which is the "
" position. Turn the knob to the "
" position, when
there is water flowing out, close the pump immediately by turning knob again to the "
" position.
The purpose of the step is that pump the water of the tank into the housing.
6. When the ready indicator (blue) is illuminated, you should turn the knob to the "
" position again,
there will be hot water flowing out. When the ready indicator (blue) is extinguished, close the pump
by turning knob again to the "
" position. The pre-heating is finished.
Make espresso coffee
1. Remove the funnel by turning it in clockwise, .Add ground coffee to steel mesh with coffee spoon,
a spoon ground coffee power can make about a cup of top-grade coffee, then press the ground
coffee powder tightly with the coffee spoon.
2. Set steel mesh into metal funnel, make sure the tube on the funnel aligns with groove in the ap-
pliance, then insert the funnel into the appliance as indicating of "INSERT" mark, and you can fix
them into coffee maker firmly through turning it anticlockwise until it is at the "LOCK" position .
3. Pour out the hot water in the cup. Then place the hot cup (yourself cup) on drip plate.
4. At the time, the ready indicator (blue) is illuminated, once the blue lamp is illuminated, you should
turn the knob to the "
" position, waiting for a moment, there will be coffee flowing out.
Note: During continuous operations, the ready indicator is likely to extinguish due to the inadequate
temperature of the water in the boiler, but it does not mean the unit will stop operating, you may
continue to make coffee regardless of it.
5.You should turn the knob to the "
" position manually when desired coffee is obtained or the
colour of coffee changes weak obviously,your coffee is ready now.
WARNING: Do not leave the coffee maker unattended during making the coffee, as you need ope-
rate manually sometimes!
6. After finishing making the coffee, you can take the metal funnel out through turn clockwise, then
pour the coffee residue out with the steel mesh pressed by press bar.
7. Press the power switch to cut off the power source.
8. Let them cool down completely, then rinse under running water.
Frothing milk / make cappuccino
You get a cup of cappuccino when you toping up a cup of espresso with frothing milk.
Method:
1- Prepare espresso first with container big enough according to the part "MAKE ESPRESSO COF-
FEE", make sure that the knob is at the "
" position.
2- Press down the steam button to the lower position which is the "
" position, waiting for until the
ready indicator (yellow) is illuminated.
Note: During continuous operations, the ready indicator is likely to extinguish due to the inadequate
temperature of the water in the boiler, but it does not mean the unit will stop operating, you may
continue to make cappuccino regardless of it.
12

Publicidad

Tabla de contenido
loading

Tabla de contenido