dirna Bergstrom bycool blue line FLAT TRP Instrucciones De Montaje página 31

FLAT
Fasten supports tightening nuts until outside
12
EPDM joint (Point 3) of equipment is com-
pressed, between 3 and 6 mm; the meeting
must be with a thickness between 19 and 22
mm
Important: To avoid water from filtering in-
side cabin, check EPDM joint tightening with
Minicool base, as indicated on diagram.
3-6mm.
Cabin roof
Fasten selflocked nut until
EPDM gasket is compressed
12
between 3 and 6 mm.
Tighten (4) M8 nuts to support and (4) to Unit
13
base.
EPDM gasket
10 mm*
(*) (approx. after tightening)
Air conditioning for vehicles
Base
Support
13
31
Check compression
thickness using a tape
measure in the four
corners.
EPDM gasket
EN ES
12