Using The Input And Output Connectors - Sony BKM-256DD Manual De Instrucciones

Overview
This unit is a DVI-D signal input adaptor for
Sony monitors. When installed in an optional
input slot on the main unit, it provides DVI-D
input and output connectors for the main unit
and a decoder for DVI-D signal.
Notes
• There are some monitors that are not
compatible with this unit.
To check if the monitor is compatible with
this unit, refer to the instructions for use of
the monitor.
• DVI-A and DVI-I signals are not compatible
with this unit.
• DVI-D dual-link signal is not compatible
with this unit.
Function
Decoder for DVI-D signal
The BKM-256DD supports DVI-D single-link
signal, which can be decoded by connecting a
DVI-D 24-pin cable.
Cable equalizer
The BKM-256DD is equipped with an
equalizer for received signals in the DVI-D
signal receiver section.
5 V output function
The BKM-256DD supplies 5 V power from pin
14 on either IN or OUT connector to an
external device.
Using the Input and
Output Connectors
For information about installing this unit in an
input option slot, refer to the instructions for use
for the monitor.
Configuration of input/output
connectors and signals that may be
input
The configuration of the input and output
connectors, and the signals that may be input
are shown below.
Input of DVI-D signal
You can input DVI-D signal to the connector
1. Also you can output the signal, that input to
the connector 1, from connector 2.
The DC 5 V supply from the IN connector, and
DC 5 V supply and output signal from the OUT
connector are provided only when the power of
the main unit is ON. For information about DC
5 V output, refer to the instructions for use of
the monitor.
Overview / Function / Using the Input and Output Connectors
1
IN
DVI-D
1 Input DVI-D signal.
2 Output DVI-D signal.
Note
GB
2
OUT
256DD
3
GB