Yakima HoldUp 2 Manual De Instrucciones página 2

INSERT BASE INTO
HITCH RECEIVER.
SECuRE HITCH
BOLT WITH
SAFETy CLIP
ANd INSTALL
HITCHLOCk.
REMOVE FASTENERS.
The fasteners are installed in the trays
for shipping purposes. remove them to
prepare for assembly.
1034426J-2/21
The holes in
the base must
align to the
holes in the
• Insert hitch bolt and lock washer, from rIgHT To lefT.
hitch receiver.
• Tighten with wrench.
ROTATE BASE TO
uP POSITION.
• Squeeze knob to release lock.
• pull spring pin to release base.
• lift frame.
• release spring pin. pin should
snap into place and lock.
FASTEN HITCH BOLT.
1 1/4" - 75 ft-lbs.
2" - 100 ft-lbs.